The MCOCOD SS08 is a soft-closing single sliding frameless shower door built around 3/8-inch tempered glass with an Enduro Shield coating on both sides, stainless steel and aluminum guide rails, and a vertical handle on the moving panel. It is designed for bathrooms where one sliding panel covers the entry and the soft-close mechanism controls how the door settles closed. This guide explains the SS08's specifications, the sizes and options available, and how to confirm it fits your opening.
Who the SS08 Is For
Single sliding shower doors suit openings where a full-width door would be too wide to handle as one panel and where a double-sliding layout is not needed. The SS08 uses one moving glass panel that slides on the rail, with a vertical handle on the moving edge, and the door operates with a light push thanks to the soft-close mechanism. It is a frameless configuration, so the glass is the structure and the hardware carries the panel rather than a perimeter frame.
The SS08 fits the same family of use cases as the sliding door category overall: bathrooms where swing clearance is limited, tub and shower openings where a hinged door would hit a fixture, and homeowners who want a frameless look without the full double-panel layout. The sliding shower door guide explains the configuration differences and when a single-sliding design is the practical choice.
SS08 vs. the Rest of the Sliding Family
The SS08 is one of three main sliding models in the MCOCOD family. The DS01 and DS13 are double sliding frameless doors with two towel bar handles and four large rollers; the DS13 adds the soft-close system, while the DS01 does not include it. The SS08 differs in configuration, not quality: it uses one moving panel with a vertical handle, two large rollers, and the same soft-close dampers as the DS13. The choice between them is driven by the opening and the entry style: double sliding gives two-sided access and is common for wide openings and tubs, while single sliding suits an opening where one moving panel covers the entry.
All three models share the 3/8-inch tempered glass, SGCC certification, Enduro Shield coating, and the same four finish options, so the decision is configuration and mechanism rather than glass quality. The sliding door size guide helps match either configuration to the opening before you choose a model.
SS08 Features and Specifications
| Specification | SS08 |
|---|---|
| Configuration | Single sliding frameless |
| Glass | 3/8" (10 mm) tempered glass, SGCC certified low-iron tempered safety glass |
| Glass coating | Enduro Shield on both sides for resistance to dirt and water |
| Soft-close | Yes; dampers on each glass panel tested for up to 100,000 cycles |
| Hardware | 304 stainless steel accessories; guide rail in stainless steel and aluminum alloy |
| Rollers | 2 rollers, 2-3/8" (60 mm) |
| Handle | Vertical handle, positionable left or right |
| Finish options | Brushed nickel, chrome, matte black, brushed gold |
All values above are taken from the SS08 product specification, so they can be verified on the product page before ordering. The 10-year glass guarantee is part of the MCOCOD after-sale terms for the glass; other details such as installation labor are site-specific and should be confirmed with the supplier.
Standard Sizes and Custom Dimensions
The SS08 is offered in a set of standard width-and-height combinations, with non-standard dimensions available for openings that fall outside the list:
- 48"W Ă 76"H
- 54"W Ă 76"H
- 60"W Ă 60"H, 60"W Ă 66"H, 60"W Ă 72"H, 60"W Ă 76"H, 60"W Ă 79"H
- 66"W Ă 76"H
- 72"W Ă 72"H, 72"W Ă 76"H
- 76"W Ă 76"H, 76"W Ă 79"H
Before ordering, measure the finished opening and confirm it falls within the selected size range, including the track and panel adjustment. The sliding door size guide explains how the width range and panel overlap work, and the MCOCOD measurement and installation guide shows the measurement sequence used across the MCOCOD sliding family.
Glass and Finish Options
The SS08 offers a choice of glass styles and hardware finishes. Glass options include clear glass, ultra-clear glass, and explosion-proof film styles such as frosted, reeded, black, gray, fabric, and the Line Black series, which combine the tempered glass base with a safety film that keeps fragments contained. Hardware finishes are brushed nickel, chrome, matte black, and brushed gold, and the vertical handle can be positioned left or right to match the opening.
The glass choice is separate from the coating: every option still carries the Enduro Shield treatment on both sides, and the base glass remains SGCC-certified tempered glass. For the appearance side of the decision, the frameless shower door guide covers how glass styles and finishes work together in a frameless build.
The film options add a safety layer on top of the tempered base: the explosion-proof film keeps fragments contained if the glass breaks, which is a separate consideration from the Enduro Shield coating. When choosing among them, decide on privacy and light first, then confirm the film style is available for the size and finish combination you want, because the option matrix is part of the order specification.
Soft-Close Mechanism: What It Does
The SS08's soft-close system uses dampers on the glass panels that slow the door as it nears the closed position, so a light push is enough to close it and the panel settles instead of slamming. The dampers are rated for up to 100,000 cycles in the product specification, and the mechanism is what separates the SS08 from a standard sliding door in daily use: less noise, less impact on the frame and glass, and fewer opportunities for the panel to bounce back open. The soft-close mechanism guide explains how the dampers work and what to check if the mechanism changes behavior.
Installation and Measurement Considerations
The SS08 installs as a frameless sliding door: the guide rail mounts to the wall, the rollers carry the panel, and the bottom guide keeps the panel aligned. MCOCOD recommends measuring after the walls are finished, confirms that professional on-site installation is available in select markets, and provides an instruction manual, installation video, and product line diagram for the SS08.
For a successful install, the wall at the rail ends needs solid backing, the opening needs to be reasonably level and square, and the floor or tub ledge needs to support the bottom guide. The installation guide covers the general install sequence, and the measurement guide explains the finished-surface checks to run before ordering.
Because the SS08 is frameless, the wall condition at the rail brackets is part of the fit: the brackets carry the panel weight through the rollers, so they need solid material at the mounting points, not tile alone. If the opening is in a surround that flexes or a wall with hollow areas, resolve that before the door arrives. The tile wall installation guide covers the surface checks that apply.
Warranty and After-Sale Support
MCOCOD provides a 10-year guarantee for the glass on its shower doors, which is stated on the SS08 product page and applies to the glass itself. Warranty terms, installation service availability, and shipping details are order-specific, so confirm them with the supplier at the time of purchase rather than assuming they are included in the door price.
Ordering and Confirming the Specification
When you order the SS08, confirm the specification in writing before production: the width and height from your finished opening measurement, the glass style, the hardware finish, and the handle position. The SS08 offers standard and non-standard dimensions, and the measurement you provide becomes the panel that is produced, so a measurement taken after the walls are finished is the one the order should use. If you are not certain about the measurement or the wall condition, ask before ordering rather than after, because tempered glass cannot be adjusted once it is made.
Also confirm what the order includes: whether the track, rollers, handle, and seals are part of the door package, and whether professional installation is available in your area. The product page and the supplier's order terms are the sources for those details, and keeping the spec sheet with the warranty record makes future part replacements straightforward.
Frequently Asked Questions
Is the SS08 a frameless shower door?
Yes. The SS08 is a single sliding frameless door: the glass panel is the structure, carried by stainless steel and aluminum guide rails and 3/8-inch tempered glass.
What sizes does the SS08 come in?
Standard options range from 48"W Ă 76"H to 76"W Ă 79"H, with non-standard dimensions available for openings outside the standard list. Confirm your finished opening measurement before ordering.
Does the SS08 have a soft-close mechanism?
Yes. The SS08 includes dampers on the glass panels that slow the door as it closes, rated for up to 100,000 cycles in the product specification.
Can the SS08 handle be installed on either side?
The vertical handle is positionable left or right to match the opening, and the door's handle position is confirmed as part of the order.
Ready to see the SS08 in detail? View the MCOCOD SS08 product page and confirm the size, glass, and finish options for your opening.