Adding a frameless shower door like the MCOCOD DS01 Double Sliding Frameless Shower Door is a transformative upgrade to any bathroom. Its sleek design and dual sliding feature add both style and convenience. However, precise measurements and a smooth installation process are key to achieving the perfect fit and function. In this guide, we’ll walk you through the steps to accurately measure your shower space and install the DS01 shower door.
Tools Needed:
Important Considerations:
Step-by-Step Measurement Guide:
Measure the Width: Use the tape measure to record the width of the shower opening at the top, middle, and bottom. If there are minor variances, use the smallest measurement to ensure the door fits.
Check Wall Level: Place the level vertically along each wall of the shower. If the walls aren’t perfectly straight, adjustments may be needed during installation.
Record the Height: Measure from the base of your shower to the height where you want the door to reach. For the DS01, make sure the height aligns with the model specifications.
Double-Check: Accuracy is essential, so repeat each measurement to confirm consistency.

Once measurements are confirmed, follow these steps for installation:
Tools Needed for Installation:
1. Install the Bottom Track:
Position the bottom track on the base of the shower opening.
Check alignment with a level, ensuring the track is straight.
Mark the drill points and drill the necessary holes before securing the track in place.
2. Attach the Side Panels:
Attach the side brackets to each wall, aligning them with the bottom track.
Use the drill to secure brackets, ensuring they are stable and aligned.
3. Mount the Sliding Doors:
Carefully lift each glass panel, sliding it onto the track.
Attach the rollers and test each door’s movement, adjusting as necessary for smooth sliding.
4. Install the Towel Bars:
Mount the towel bars on the exterior of each door panel, following the provided instructions.
Ensure they’re securely attached, avoiding overtightening to prevent glass damage.
5. Final Adjustments & Sealing:
Verify all parts are securely installed and that the doors slide smoothly.
Apply silicone sealant along the edges to prevent water leakage, then let it cure for 24 hours.
6. Clean & Inspect:
Clean the door panels and check all components. Test the doors to ensure full functionality and seal strength.
After installation, keep your DS01 shower door looking and performing like new with these maintenance tips:
Installing the MCOCOD DS01 Double Sliding Frameless Shower Door doesn’t have to be a complex process. With precise measurements, the right tools, and attention to detail, you can achieve a flawless installation that enhances the beauty and function of your bathroom. Follow these steps to ensure a perfect fit and a seamless, modern finish. Enjoy your upgraded shower experience!
Soft-Closing Frameless Shower Doors Double Sliding Shower Doors Frameless Shower Doors Single Sliding Shower Doors Bathtub Shower Doors Framed Shower Doors Custom Shower Doors Shower Door Hardware MCOCOD Bathtubs Bathroom Mirrors